FPV 433Mhz Radio Telemetry Kit 100mW

FPV 433Mhz Radio Telemetry Kit 100mW

Mensagempor Soaron » 11 set 2013, 17:52

This radio telemetry system is designed as an open source Xbee replacement radio set, offering a lower price, longer range (approx one mile) and superior performance to Xbee radios. It’s available in 915Mhz and 433Mhz; and in the following configurations: serial board (for the air) and USB (for the ground).

The system provides a full-duplex link using HopeRF's HM-TRP modules running custom, open source firmware. Interface to the module is via standard 5V-tolerant TTL serial / FT232 USB serial.

The SiK firmware includes a bootloader that permits radio firmware upgrades over the serial interface, and radio firmware with configurable parameters. Firmware upgrades and configuration are fully supported in the APM Mission Planner. Configuration is also possible through the 3DR Radio configurator and AT commands.

• Very small size
• Light weight (under 4 grams without antenna)
• Receiver sensitivity to -121 dBm
• Transmit power up to 20dBm (100mW)
• Transparent serial link
• Air data rates up to 250kbps
• Range of approx 1 mile
• MAVLink protocol framing and status reporting
• Frequency hopping spread spectrum (FHSS)
• Adaptive time division multiplexing (TDM)
• Support for LBT and AFA
• Configurable duty cycle
• Built in error correcting code (can correct up to 25% data bit errors)
• Demonstrated range of several kilometers with a small omni antenna
• Can be used with a bi-directional amplifier for even more range
• Open source firmware
• AT commands for radio configuration
• RT commands for remote radio configuration
• Adaptive flow control when used with APM
• Based on the HopeRF HM-TRP radio module, featuring an SiLabs Si1000 RF microcontroller

'Air' and 'ground' variants, FT232-style pinout and USB connector, respectively
RP-SMA connector
Maximum output power of 100mW (20dBm), adjustable between 1-20dBm
-117dBm sensitivity
Standard TTL UART interface
Data transmit and connection status LED indicators
Dimensions (USB board for ground): 55x17mm
Dimensions (Serial board for air): 46x20mm
Weight (USB board for ground): 7.5g
Weight (Serial board for air): 5.6g
This product is based on the 3DRadio project by 3D Robotics.

Não tem Permissão para ver os Ficheiros anexados nesta Mensagem.
Avatar do Utilizador
Membro com baixo nível de participação
Mensagens: 11
Registado: 25 fev 2010, 19:38

Re: FPV 433Mhz Radio Telemetry Kit 100mW

Mensagempor ares » 25 fev 2014, 23:40

Boa noite,
ainda tem o "FPV 433Mhz Radio Telemetry Kit 100mW" para venda?
estou interessado, de que zona é?
deixo aqui o meu contacto photoptica@gmail.com, fico aguardar a sua resposta.

com os melhores cumprimentos

Jorge Tavares
Membro com baixo nível de participação
Mensagens: 2
Registado: 25 fev 2014, 23:33

Voltar para Helicopteros

Quem está ligado:

Utilizadores a ver este Fórum: Nenhum utilizador registado e 2 visitantes